Welcome to the official website of Qingyang Fuyun Moving Service Department in Fushan District!


categories of news

Product Categories

contact us

Fuyang District Qingyang Fortune Moving Service

Contact: Manager Ma

Mobile phone : 15098661597


Address: Fuyun, Qingyang Road, Fushan District, Yantai City


Method for disassembling air conditioner when moving in Yantai

Your current location : Home >> News >> Company News

Method for disassembling air conditioner when moving in Yantai

作者: 福山区清洋福运搬家服务部点击: Release Date: 2019-08-23 Author: Qing Yang Yun-Fu Fushan Moving Services Views:

When moving, air conditioning How to disassemble it? This general professional moving company has a special person in charge, but if we dismantle it ourselves, what should we do? Let ’s move to Yantai to explain how to remove the air conditioner when moving.


When dismantling the air conditioner in Yantai , it is necessary to collect the refrigerant in the air conditioner and collect it into the outdoor unit. Start the air blower before disassembling, you can set the cooling state, wait for the compressor to run for 5-10 minutes, after the cooling state is normal, unscrew the cap on the interface of the liquid pipe and gas pipe of the external machine, and close the high pressure pipe After closing the valve for 1 minute, dew condensation occurs on the surface of the tube. Close the low-pressure pipe (coarse) stop valve immediately. Shut off the power immediately, unplug the power plug, and tighten the safety cap with a wrench. The refrigerant recovery is complete. You can also use the forced start button on the indoor unit to start up, and observe whether there are other failures in the indoor and outdoor units. Avoid troubles when the air conditioner is moved.


After disassembling the refrigerant from the indoor unit, the indoor unit can be disassembled. Use a wrench to unscrew the indoor unit connection lock nut, and use a prepared sealed sodium screw to protect the wire pattern of the indoor unit connection connector to prevent damage to the connector wire pattern during transportation; then use a cross to remove the control wire. At the same time, it should be marked to avoid wrong connection during installation. If the signal or power cables are connected incorrectly, the external machine will not run or the machine will not be controlled. The hanging plate of the internal machine is generally relatively fixed, and it is difficult to remove it. After removing the hanging plate, place it on a flat concrete floor, and then gently flatten and correct. Take good care of the silk pattern of the external connection connector. Then use a wrench to loosen the fixing screws on the feet of the external machine. When disassembling and lowering the outdoor unit, it is better to hang it with a rope. At the same time, pay attention to balance, avoid vibration, bump, and pay attention to safety. The outdoor air conditioner should be slowly taken over, and the four ports of the connection tube should be sealed with the prepared four plugs to prevent dust and water from entering the air. Close the plug, and then tie it with a plastic bag.

The above is a summary of the removal method of air conditioners when moving in Yantai . I hope everyone has a certain understanding. If you want more information, please continue to pay attention to us.


URL of this article:

Keywords: Yantai moving company , Yantai moving company , Fushan moving company

Recently Viewed:

  • online service
  • contact number
  • Leave message
  • Online consultation
  • qq number
  • Welcome to leave us a message
    Please enter your message here and we will contact you as soon as possible.
    Contact person
    Landline / mobile number